Answer Posted / wasim
Stean engine or oil engine or motor are usually rated in HP
because these mation drive another machine soits power is
termed as mechanical power hence it is rated in hp.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
The shot circuit in any winding of transformer result? Explain
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
what irequirment need to be followed when working on live equipment
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
how single phase preventer works ?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
Difference between rating factor of cable and derating factor of cable?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how to check ac servo motor
working principle a.v.r. ?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
