Answer Posted / abdul hamid
Prestress Concrete advantages:
1)Reduced section of member (saved concrete quantity)
2)Induced negative bending moment before putting in to
loading condition, so concrete tention failure avoided.
3)less quantity of reinforcement.
4)Due to compressed concrete, higher load bearing capacity
of member.
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Sometimes the side of concrete bridges is observed to turn black in color. What is the reason for this phenomenon?
A super elevation of 60 cm has been provided on a 8m wide road and a curve of 260m radius .calculate the max.speed in km/hr of the vehicle that can be negotiated safely? Plz answer with full solution.thanx
how to take the quantity of block work and plastering 1block price:3saudi riyal cement:1bag:15 saudi riyal sand:3bag:20 saudi riyal 1mason:9hour per hour 40 saudi riyal 1labour:9hour per hour 40 saudi riyal can anybdy calculate
What is the Null Point of chimney in Power Plant
what are the types of dimensioning?
Elaborate advantages & disadvantages of using crusher dust instead of sand in rcc work.
Why is the statue of liberty made of copper?
a concrete mix 1 2 4 by volume with water cement ratio as .6 by weight if moisture content in F.A is 6% with 20% BULKING AND IN C.A 1.5% by volume. find quantities of different materials required for one bag of cement
Advantage of Aluminum form work in terms of activities can be skip and cost too
The largest size of paper used in plotter to print the drawing made by Autocad .
what is the minimum reinforcement provided in beams,footings,slabs? what is the minimum soil bearing capacity to design a multistorey building
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
what is the mix design for M:60 with micro silica andmetakaoline?
what are the types of design? which type of method is used at what type of design & why?