Interested to Buy Any Domain ? << Click Here >> for more details...
in a power plant main steam flow is volumetric or mass flow?
is it required compensation?
- 1 Answers
- 5372 Views
- Wartsila, I also Faced
- E-Mail Answers
Answer Posted / bablu choudhary
If, we use LPT and HPT used for full STIG ,then volumetric flow rates of the turbine is to be constant to maintain the pressure ratio of gas turbine while the mass flow rates of the STIG is lower than that of gas turbine.
so compensation is not required in case of mass flow rate it only allow to flows the volumetric flow rate.
THANKS.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
Explain the working principle of lvdt?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
How it the difference between force balance system and dispalacement balance system?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Explain about safety integrated level protection? . How it was differ from other protections ?
how to calculate range of level transmitter?
how to measure oxygen which methods are using?
when a magnet is heated?
What is the use of control cable?
how to measure draft pressure in transmitter pl. give its single line digram
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
