What is the syllabus for Instrumentation Engineers, who wish
to join the Public Sector Units??
- 1 Answers
- 2910 Views
- I also Faced
- E-Mail Answers
Answer Posted / gaurav singh
in a close loop system the output is taken without feedback
and output is depend upon the reference input
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is wave length were using ?
what is loop1 and loop2 in MTS LT?
What is instrumentation instrumentation engineering?
Explain Gas Turbine startup and shutdown sequences
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
how the arrangement of equipments done in control room
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
How to measure the dust in chimney(spm)?
What is 1:1 redundancy ?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what is interface level measurement.who can calibrate interface level measurement transmitter online
what is the input of digital counter during the the calibration time?
What are the interlocks we have to check during the start up of LP/HP compressor?
what is cold loop? difference between hot and cold loop?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
