What is the function of Lightning Arrester & Wavetrap in
Power system ??
Answer Posted / s madhukar
Lightning Arrester is a device used on Elctrical Power
Systems. It is used to protect the insulation of the
system.When a lighting surge travels along the power line
to the arrester, the current from the surge is diverted
through the arrestor in most cases to earth.
Wave Trap is a device used on Electrical power sysems. It
can descriminate the Power Frequency waves and power
communication waves and it reduce the noise and
interference from line.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What is meant by coupling capacitor?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
i want to model paper for section engg.
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
how many joints are allowed in underground HT cable of 1 KM
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
how to calculate mf when meter and cTPT detail are given
What are the advantages of speed control using thyristor?
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
what does mean of RCT and STR in diffrential CT?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
State thevenin’s theorem?
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?