Interested to Buy Any Domain ? << Click Here >> for more details...
What is OLTC in a transformer, specify its fuction.
- 35 Answers
- 142274 Views
- Bhel, Isgec, L&T, I also Faced
- E-Mail Answers
Answer Posted / manoj kumar
oltc is on load tap changer. it is typical winding
connecton for a resistor type high speed oltc provided at
the neutral end of eaach phase of windings of a star
connected 3-phase transformer.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
What is VSCF windelectrical system?
Why we are use dol starter up to 10 hp
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
What is the Surge suppresor? Why using in a UDB's and How it works?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
STATE WORKING OF VACCUM CIRCUIT BRAKER?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
Why power genaration in India is at 50HZ while America its 60HZ
How to convert 2 phase to 3 phase electricpower in induction moter?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
how to calculate the formula of cable size if motor kw is given
how many types control panel of a 132/33 kv substation
