Interested to Buy Any Domain ? << Click Here >> for more details...
what are the settings is there for ABB REM543 Generator
Protection Relay
- 1 Answers
- 6566 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
GENERALLY,WHEN THE COMMISSIONNG IS DONE WITH SHORT CIRCUIT
TEST, ALL PARAMETERS ARE SET FOR ALL PROTECTION RELAYS-
NAMELY: i) differential protection
ii) Over current,instantaneous over current
iii) Unbalanced current ( negative sequence)
iv) loss of ecxcitation.
v) reverse power
vi) Under voltage.
viii) over voltage
hence it is not necessary to repeat .
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why output is out of phase in case of common emitter?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
What is sink and source?
why three phase capacitor takes unbalanced current in capacitor bank?
why not starting switch first connect in direct on line starter?????
How to calulate Locked rotor amper(LRA) for compressor type motors?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
upto how many load can v connect to stabilizer which is used for tv
How to know the Max. current caring capacity of the cable by its size ?
What is the diff. between single compression and double compression gland
How to calculate the fuse rating depend upon the DC circuit?
When lag/lead/lag-lead compensation is employed?
What is making & breaking current ???
