How to test and satisfy the conditions of the vector group
YNd1 for power transformer?
Answer Posted / a.p.nanjappa
THIS IS ONE OF THE MANUFACTURER TEST OF VECTOR GROUP.
IN THIS TEST , THE HV RPh or Uph is connected to low voltage
rPh. /uPh. then 400v 3ph is applied. various voltage are
measured. (RS,ST,TR, R-N,S-N.T-N, r-s,s-t,t-r, r-N,s-n,t-n.
then, draw the graph,
refer to electrical hand book-transformer, any text book
also,manufacturer test report
Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
What is ideal IR values for ground and neutral.
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
What is the different between digital phase converter and ordinary phase converter?
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
Which type of transformer is used for lighting loads?
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
What is the real function of reverse power relay in generator panel while syncronising?
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
Dear friends I want to design busbar for1600 kva transformer(i.e2100 amps) what are all the factors to be considered before selectinga busbar what are all the standard sizes of busbars what is the formula for finding current of copper and aluminium busbar
What will be the effect if I use inverter as UPS mood?
what is transient voltage?
why should the primary of transformer be connected in delta in a heat run test?
Rules and standards of electrical control wiring ?