Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by PU value ? anyone can you explain briefly to
me ?
- 3 Answers
- 5436 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
PU means PER UNIT VALUE.
this is used by protection engineers application.
refer CEGB, ABB,SIEMENS HAND BOOK FOR CALCULATION OF FAULT
CURRENT.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Grid fault level [KA]?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
What happens when two positively charged material is placed together?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
Dear friends, i would like to know that what is the exact function of 'exciter winding' & 'aux winding' in Alternator?
Explain about technical and non technical losses in distribution system?
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
What type of pipe material G.I or M.S is used for sprinkler system?
How cable from Kit-Kat to main switch, from starter to motor are designed?
What is power factor why we should maintain the power factor unless what will happen
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how wecalculate breaking capcity of acb mcb mccb .explain with example
How to Calculate KA Rating of Main LT Panel
what is difference between earthingpits,earthing grid & earthing mess?
