Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between Earth Fault protection &
Neutral Protection
- 1 Answers
- 4489 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
as you are aware, in electrical engineering power
transformers or motor winding are connected in star-
undrounded or grounded,Delta connected.
Earth fault protection may be due to capacitaive
circulating current,flowing through the body of equipment
to ground. In large generator,motor it may be 5-10A
unbalanced current flowing through Neutral to ground, and
also fault current sigle phase to ground,double phase to
ground,or three phase to ground.these are severe
faluts.damages equipment severly.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
Inductor and capacitor........power in one phase and ...... in it another phase.
what is meant by power and distribution transformer ?
Please explain me about Relay curves and their sources to read ?
why we are using Load factor?
700KW 6.6KV slip ring induction motor to use VFD to control the speed
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is the permissible maximum flux density in transformer core?
What is meant by vector group
kindly send me 11KV MV motor differential protection procedure by primary injection method.
