Interested to Buy Any Domain ? << Click Here >> for more details...
If not maintained 3 phase clearance,what happened ?
- 2 Answers
- 3787 Views
- I also Faced
- E-Mail Answers
Answer Posted / shri..
it will bet short if clearence is less
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
Define noise?
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
please explain how to do 'pole drop test' on generator?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
how to calculate the breaking capacity of different breakers.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
how much GROUND & NEUTRAL VOLT maintain in data center.
What are the basic & Majour problems in UPS ?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
