Interested to Buy Any Domain ? << Click Here >> for more details...
y we are used signal conditioner in capacitive transducer
- 1 Answers
- 3608 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajeshsonic
capacitive transducer has
low snesitivity
output change wrt input is not significant with large value
of input signal
poor linearity i.e output is not proportional to input
here output is capacitance change ( converted to voltage )
and input may be distance / level / pressure measurement etc
]
we use opamps for this demerit
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
Define cuttoff frequency?
What is steady state response?
What is a parabolic signal?
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
what happens if earth of 33kv cable is not connected to earthing pits? please send this query's answer to ngrm.sudha249@gmail.com
show the single line diagram of star delta starter with single phase preventer
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
Why an ac solenoid valve attract the plunger even though we interchanges the terminal? Will the poles changes?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Why neutral point is consider as zero potential?
Pls mail me utility & Dg related question with answer
