Answer Posted / master ramunniraja
CT Primary turn wire thickness is very thick compared to
secondary wire. Primary having only one turn.
PT Primary and secondary wires are thin depend upon the
rating of the transformer.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
where reactive power is used
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
Why 9KV surge arrester having 7.65KV of MCOV?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
how solar power plant energy meter multiplication factor
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
star delta starter contorl circuit... drawing..
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
difference between power surge and switching transient
what is through fault?
what is mind in cable
what is metering cum synchronizing panel and how it is used?