what is meant by PU value ? anyone can you explain briefly to
me ?
- 3 Answers
- 4226 Views
- I also Faced
- E-Mail Answers
Answer Posted / varun
per unit value
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
What is turn ratio of a transformer?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
what is magnetizing and demagnetizing current in generator and motor?
what will be project cost for 100 kv transformer connection under oyt scheme.
What is steady state response?
Give some differences between open loop and closed loop?
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
Is MEN and RCD related to each other ?? IF yes then how??
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
what is vtg limit of earth and neutral at transformer side?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
