Answer Posted / chandra chood pandey
PT is a potential transformer which use to measuring a
voltage
EMVT is same as the PT both are the use for the volage
measuring but accuracy is high of the EMVT.
CVT is voltage transformer but it works on capacitance. and
it is also used for the PLCC
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Difference between Earthing Truck & Earthing trolly for HT panel
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
How shall i select the value of capacitor or inductor in a system?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
why it is so called as xlpe(cross linked poly ethyline) cable?
what is the common earth
What is systematic error?
what are the steps involved in generator load test?
Why earthing is necessary for any equipment?
Sate maximum power transfer theorem?
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
should %impedance be high or low in a power transformer? if so why?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
