why steel is used in r.c.c
why steel is used in r.c.c
Answer Posted / vadivel raja
co-efficient of thermal expansion is relatively same for
both concrete and steel .. . . .
for steel=12x10^-6/'c
for concrete=10x10^-6/'c
Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
How to estimate the shuttering material requirement for a slab and beam and shear wall..? Please send thumbrule to estimate material required ( Plywood, Ms plates, runners, acrospans, jacks)
How many bricks are there in 100cft?
why we use for testing of compression strength concrete the size of specimen 150x150x150. why we are not using another dimension like 100x150x100 uneven dimension.
while doing the structural works of a simple ground+1 villa, can the columns be continued immediately after neck columns without tie beam, while the tie beam to be done after columns concreting.
As in practice, we are deducting every 2d for 90 degree bend but from where it comes means derivation or reference of IS Code.
Explain the importance of moment of inertia?
mix design procedure for 1:6 cement mortar
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
Currently my house construction is going on but we just realized that the portico earth beam couldn't connect with the original earth because the beam rod not extended so Please advice
Cut Linten (RCC-1:2:4)on 10" wall - what should be the width and hight of cut Linten? Secondly, 1 X 1.6 foot,4" thick window sun/rain shed (Chajja)should consume steel,Cement, sand and Stone chips?
how to diffenentiate the fixed beam and simply supported beam in the execution while reading the drawing and how the reinforcement detail will be differ for the above.
how to estimate costing from quantity givin in BOQ and according to this how we fill tender and final rate for perticular work.....?
what is the calculation of raw material for 0.35cum of m-15
Define What is the force exerted by the Tacoma narrows bridge?
What is the largest concrete dam in the world?