Interested to Buy Any Domain ? << Click Here >> for more details...
what is the output of conductivity sensor and PH sensor?
- 3 Answers
- 7872 Views
- I also Faced
- E-Mail Answers
Answer Posted / mithilesh kumar
o/p is mv.and o/p goes to
transmitter i/p.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
How to check vortex flow meter is in good condition while we do not having calibration setup?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
What are different types of orifice plates? State their uses.
what is droop in governer ,type of droop ,how it work
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
what is the protection system in solar turbine compressor
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
what is the imbustion control loop
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
