Interested to Buy Any Domain ? << Click Here >> for more details...
why are you use the crgo core lamination in transformer
- 6 Answers
- 9538 Views
- I also Faced
- E-Mail Answers
Answer Posted / arun kr vidyarthi
Low eddy current loss & Hystersis loss
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What type of a DC motor would you use for a lift?
What are two contours of nichols chart?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What are the two basic types of transformers?
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
I Want randstand placement papers
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
Why does the radius of armature is less than the radius of pole shoe?
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
what is the method of earthing of a transformer using electrodes?
What are the advantages and disadvantages of the dc motors?
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
