Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / chad
Assume an AC sin supply then when measurement is taken,
then the test instrument used could be crossed over. The
same result however will be as positive. This also assumes
the voltage is in phase with the current. You can not have
negative power. Out of balance phase current and voltage
will mean inadequate supply to the load. Negative current
would need investigating.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
l&t switch FN 63 handle position can we change
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
What is Instantaneous Earth fault relay,how will work
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
What are the advantages and disadvantages of closed-loop control system?
what is there inside an inverter and how it works?
Why AC & DC capacitor are use in UPS ??????????????????
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
What is the function of attenuator in cro?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
