Answer Posted / omak
In DCS system , their is an option called third party interface.this third party interface is mostly in serial communication method. so by using the third party interface card, we can connect the PLC using serial communication method.
Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
What are different type of instrument cable
can you provide me full detail about instrumentation in ONGC??
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
typical loop drawing of a simple feedback control comprising of one transmitter and one control
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What is furnace draft control?
How to decrease opening & closing time of on/off valve?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Hook up resistance decade box to temp.transmitter.