Interested to Buy Any Domain ? << Click Here >> for more details...
How much load can give on 1600 kva transformer 11kv/440
- 5 Answers
- 16721 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
1600 kva using the parameters the mfg provides. If your
environment is different that those under which to mfg
provides then you will need to adjust the rating.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
where the lexical paramater will use in fron end?
Advantage of LT panel vs HT panel
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
how current is reverse from its normal direction during the fault?
IN 1000kva transformer where the oil and winding temperature sensors is connected
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
What are locations arc protection relay is fixed.
is ac supply can store
