Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 364119 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / reema
electrical obeys ohms law but electronics doesn't obey ohms law....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
From what on-site components does the HT panel monitoring the bus-bars in a 11kV system take inputs?
what is the difference between droop mode and ischnorous mode in thermal powerplant?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
in 132kv substation CRT means
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
Explain different types of d.c motors? Give their applications
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
Wind mill
