Interested to Buy Any Domain ? << Click Here >> for more details...
what is the minimum insulation resistance for HT AND LT motor
?
- 3 Answers
- 8238 Views
- I also Faced
- E-Mail Answers
Answer Posted / jsvankar
The minimum insulation resistance is HT < motor's "rated
voltage in KV plus one megaohm"
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
what is model question rrb junior engineer electrical gr.II
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What information we need to prepare relay coordination chart
why we use copper earthing for neutral while for body GI.
Leakage current,un balance current which relay using for high voltage transmission?
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
State nyquist stability criterion.
What is the suitable transmission voltage?
How do we calculate over and under frequency tolerance from generator data?
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
What is meant by harmonic distortion?
