Answer Posted / balram

=8*8

Explain how you can turn off the display for dimension in CAD?

1104

---

I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.

2036

---

Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?

2071

---

how can we calculate steel value, depending on load

2240

---

how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???

1869

---

how to calculate steel for slab or footings?

1610

---

What do we mean by partial moment release ??

3818

---

What is reinforced concrete?

1071

---

A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals

2195

---

how to take concrete quantity for precast segment for viaduct project?

3058

---

WET BULB TEMPERATURE AND DRY BULB TEMPERATURE?

2307

---

hai, kindly send anyone for output workers format details for construction project in foundation to finishing.

1466

---

How to find CN by using arcgis 9.3?

2371

---

in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing

3813

---

what is the types of door's wood?

2033

---