Answer Posted / hghg
Bus coupler is a device which is used to switch from one bus to the other without any interruption in power supply and without creating hazardous arcs. It is achieved with the help of circuit breaker and isolators.
| Is This Answer Correct ? | 28 Yes | 9 No |
Post New Answer View All Answers
What Maximam Gap Taibaar & Bush
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
what is difference between cpp electrical system and refinery electrical system
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
Can any body tell gulf interview question for experienced electrical engineer ?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
What is the tube exial fan?
Why reactors use before incoming of ac vvfd drive?
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
difference between servo motor and synchronous motor
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
What is a Phase shift meter? Where can I get one?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
what are the application of over current relay?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
