Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use a H.T. Fuse from a thick wire, on other side we use
high rating of cables?
& Why we use less Sq. mm Cable on H.T. side , on other side we use Large Sq. mm cable?
- 1 Answers
- 8216 Views
- I also Faced
- E-Mail Answers
Answer Posted / anurag pattanayak
what kind of question is this?
anyway...with watever i could make out of your question..
HT = very low current..So fuse wire rating should be low..hence Sqmm is low...
and vice versa for LT
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How to do stting of vl250 siemens MCCB
what is errection pcbs?
What are the basic properties of signal flow graph?
What is polar plot?
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
Graphs of measuring power and speed on dc motor
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
What is the disadventage of gland earthing(power cable) if any. ?
What is advantages of VSCF wind electrical system?
design a 3 bit synchronous and asynchronous counter using T- flipflop
Can a generator runs after getting 1st stator earth fault.
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
What are the specifications for conducting earth leakage test as per IEC standard?
will 1050kva DG set withstand for back charge of 16MVA transformer
