Interested to Buy Any Domain ? << Click Here >> for more details...
What is the purpose of using Pro-e, Ansys, AutoCAD...?
Before establishing these softwares how the complex jobs
were designed manually?
- 2 Answers
- 13867 Views
- I also Faced
- E-Mail Answers
Answer Posted / l.raghuraman15
In AutoCAD we are drafting the jobs in 2-D which may not
give the clear view of the object. But in Pro-e we can get
clear view of the object in 3-D. By using ANSYS we can save
the materials since we can apply and get results without
destructing the materials.
By using these softwares we are analysing a job without
wasting the material. But eventhough the jobs were analysed
using softwares they are performing a practical operation.
Why? Whether they are checking the results got in that
softwares?
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Tell me how you are ready to comply with the employment rules and regulations if your CV is considered for employment?
Which country has the worlds most powerful tank?
What is difference between Higher calorific value and lower calorific value?
whether anyone has VEDANTA written question papers?if so send me soon i've placements in dec 2nd week
What is the maximum P-max for a cylinder in M/E.
Did you have a favorite project that you had to do while in school?
relation of cop with ikw/tr?
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
why oil lift in screw chiller during change of climate.
Explain the advantages of powder metallurgy?
interviw tips for bhel supervisor trainee
composition of cast iron fc-500,fc-550,& fc-260 which is use in sheet metal industries as a piller set
Fabrication Defects
When repacking a valve the rings of packing should be oriented so that the packing ends are installed ____________.
