Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anbumozhi r
The cosine angle between voltage and current is called as power factor
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why DG set is not installed in Terrace ??
What is the role of power pack in substation protection system?
What is meant by a stray loss of a induction motor??? What is the equation to find it
where lt & ht capacitor used
What are dcs and plc?
How to calulate Locked rotor amper(LRA) for compressor type motors?
Differentiate between induced emf and self inductance?
What is the difference between Delta & Wye windings?
state working of halogen lamp?
what irequirment need to be followed when working on live equipment
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Explain about c.t?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
