Interested to Buy Any Domain ? << Click Here >> for more details...
what is the function of turbo charger in disel generators
- 1 Answers
- 4950 Views
- Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / jayprakash
A turbocharger, or turbo (colloquialism), from the Greek
"τύρβη" (mixing/spinning) is a centrifugal compressor
powered by a high speed turbine that is driven by an
engine's exhaust gases. Its benefit lies with the compressor
increasing the mass of air entering the engine (forced
induction), thereby resulting in greater performance (for
either, or both, power and efficiency). They are popularly
used with internal combustion engines (e.g., four-stroke
engines like Otto cycles and Diesel cycles). Turbochargers
have also been found useful compounding external combustion
engines such as automotive fuel cells.[1]
The term turbocharger is a modern one, derived by shortening
the turbosupercharger, which was widely used during the
World War II era and earlier. This term refers to the fact
that turbochargers are a specific type of supercharger, one
that is driven by a turbine. The most common form of
supercharger at the time, which was often referred to as a
"geared supercharger", was mechanically driven by the
engine, whereas turbochargers are always driven by a turbine
that gets its power from the engine's exhaust stream.[2]
Twinchargers combine a supercharger and turbocharger.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
what is meant by vector group of a transformer? How can it be derived?
is it possible to start a motor in felid connected to a remote mcc
Could you measure voltage in series?
What is the voltage gain or transfer function of amplifier?
What type of fittings and electrical accessories can be install in radiation area ?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is meant by flywheel and its role in retardation test
Why is a plain induction motor unsuitable for wide speed control?
how we provide neutral earth on synchronising panel as per electrical standards?
where we use the SFU & FSU?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
orifice sizing how done, checking & selection
