Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between 5P20 class CT , PS Class CT
and 5P10 class CT??
- 5 Answers
- 149318 Views
- I also Faced
- E-Mail Answers
Answer Posted / veera
in 5p20 5 is 5% of the 20times of the primary current(i.e)
in case 100/1A CT 20*100=2000A 5% is 100A ERROR AT 2000A
fault cuurent for instantaneous trip this error is
negligible
| Is This Answer Correct ? | 67 Yes | 19 No |
Post New Answer View All Answers
What is the effect of pd controller on system performance?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
(In MEP services) HVAC in AC Plant room what else can we provide if the chiller is not considered?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
What happens to voltage when current is zero?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
how to ctrl motor by use of ac or dc drive.plz explain evdintly
What are the basic elements used for modeling mechanical rotational system?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
