Answer Posted / kiran moida
If the receving signal is in between the limiter amplitude
the signal will not be distroyed. in case if its range out
of limiter we receive the signal with distortion. In first
case it is useful in avoiding noise and in second case it
deducts required data. So limiter should be adjusted as per
the data we receive (amplitude we receive).
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why the circuit turn off time should be greater than thyristor turn off time?
what is ISDN-PRI Support
What are the commonly used filters?
What are the uses of memristor?
hi .. i have done my b.e in under electronics and communication engineering and now i have opted for computer engineering which has most of communication related subjects. still what should i answer, if i am been asked "why didnt yu opt for electrical engineering"
What is meant by positive converter group in a cyclo-converter?
What is q-factor of the coil?
I am a fresher and i have done testing course from orbit institute hyd.can any1 say me whether it is necessary to do project in testing.if it is that which is best institute in hyd.can you please inform me if there is any job 4 freshers.thanxs
What is noise in modulation?
y u looking for a job in it field sinc u r a ece graduate.
Why should you chosen this job
How the cellular phone is working?
Draw and explain a mod-10 counter.
what is semi&full custom difference b/w these two?
What are the advantages of igbt over bjt, mosfet?