Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashok patel
Controller gives 4 to 20 mA signal to I-P converter & I-P
converter gives 0.2 to 1.0 Bar air pressure to control valve
for open or close operation against the balance force of
actuator spring.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
What is instrumentation control?
what is the input of digital counter during the the calibration time?
Why are the uses 24vdc in industries
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
Describe the function of Accumulator into the Pump
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How INtools is useful for routine Instrument maintenance?
Do you have reference list?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
What is zone,loop/fire alarm system?
