2. If 8.35%Z means the percentage impedance of 132/11kV
transformer self,will like to reconfirm the percentage
impedance that is supplied from power company?
- 2 Answers
- 5402 Views
- I also Faced
- E-Mail Answers
Answer Posted / markandeya
%Z is something related to transformer winding.
it will deside the fault level of the transformer.
if u give (132*8.35/100)volts instead of 132V to you
transformer,
short circuit current = full load current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A double circuit with dog conductor 66KV Transmission line from wind farm evacuation to feeding substation having capacity of 25MW for transmission. Can same transmission network be considered for further expansion of Power & how much in MW. If we need to expand next 10-15 MW more will there any augmentation is required in transmission network? Kindly reply asap.
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
Safety of dry type transformer
what are the stresses in circuit breakers ?
List the time domain specifications.
what are the difference between PLC and embedded
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
What are the properties of a resistor?
how point on wave controller works.
Why can't we parallel the secondary circuits of two voltage transformers?
Define maximum demand?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
