Interested to Buy Any Domain ? << Click Here >> for more details...
Is it legal of using 3 phase motors in 2 phase in Tamilnadu?
- 2 Answers
- 4304 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
You need to ask a lawyer if it is legal. However if you do,
the motor will turn to smoke
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
in science exhibition how lamp can blink when you clap near the lamp ? thank you
How many types of electrical earthing are there?
Can an inverter be used as a converter? How?
what is earthing transformer? draw the winding dia.of earthing transformer.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
How we select the vector group of 3phase power transformer?
IF DISTANCE IS 100METERS B/W AMP.METER AND CURRENT TRANSFORMER WHAT WILL BE AFFECT IN ACCURACY .METER CAN SHOWING ACCURATE CURRENT OR NOT IF NOT WHAT CAN I DO TO GET 100% ACCURACY.
why don't we use the generator as a motor? and what will happen?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
What is The Resistance Formula
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
what is the write prosidure of stringing of 8meter pcc pole.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
