Answer Posted / ghulam muhammad
Casecade loop is used where the one variable is affected by
other variable and also for slow process.this is series
arrangement of two or more loops in wich the output of one
controller becomes the setpoint of secondray controller for
correcting the manipulated variable.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to measure the dust in chimney(spm)?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
What is profibus?
What are different types of cable?
What is the use of GMV in turbine?
How digital input and digital output 's are working in dcs
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
how to calibrate 0- 150 psi presure gauge by dead weght tester
what is the difference between active & reactive power?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.