if an alternator or turbine using fuel to produce ele energy and we didn't connect load to the ends then where was gone the ele energy
Answer Posted / ghanshyam_singh
quite satisfied with the previous ans. simply the speed of the rotor will increase because there is no opposing force which acts on rotor.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to size H.T & L.T Panel ?
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
which is the best institute for PLC,SCADA,DCS in hyderabad
How we calculate DC inducation moter Amp? Sir pls give me formula......
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
number of I/O devices in siemense plc
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
Initially, when the input is not equal to the output — what type of response is this?
can anybody sent me power grid questions. what subject should i prefer for preparation?
why h parameter are called as hybrid parameter?
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
what is doid
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?