Answer Posted / jaguper
Power factor is angle between the voltage and current,angle between the voltage and current is 90 degree...actually power factor indicate a power loss...PF depend upon the voltage..
Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
what work will do diffrential realay DG set
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
Earth has zero potential then what would be the neutral potential ?
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
what is mean by restructuring power system?
A jet of fluid strikes a plate What was the force required to counter it?
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
can anybody sent me power grid questions. what subject should i prefer for preparation?
what kelvin's law ?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?