Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / wareagle
Google "Does the Impedance of the source affects the THD"
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
DG cranking voltage?
How to back charge the Gas turbine generator
What type of fittings and electrical accessories can be install in radiation area ?
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
Why the power factor improvement is so important in industrial loads
Differentiate between Zero and Negative sequence current
what is mean by PIR in circuitbreaker and give me detail of that?
What is reactive power and where it is used.
I have a 380 KVA DG set. How can i find out 1. My Fuel Consumption per hr ? 2. Electricity produced in 1 Hr. ? 3. If load varies then how does it affect fuel consumption & electricity produced ? Please HELP !!! Really need an answer.
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
why 1.7Uo for HV cable Hi pot test?IE standard why?
How to work meggar?
