A motor is taking 15 Amps at no load and 60 Amps at full load.
and a valve has to open 10% at full load and 80% at no load.
How to draw ladder logic.(PLC).
Answer Posted / amit gathiya
YOU NEED A CURRENT TRANSDUCER AT YOUR MCC WHICH CAN GIVE YOU
THE 4-20mA SIGNAL WITH 0 TO 70Amps. proportionally.
USE LESS THAN & GREATER THAN BLOCK LOGIC FOR OPEN & CLOSE
THE VALVE.
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Identification of ss fittings, pilot valves, relief valve.
selection of the zener barrier for the hazardeous area zone 0
What is instrumentation measurement?
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
What is cut off relay? And why use in PLC and DCS?
State some of balance principle’ advantages?
What is the diffrence between ff tx and non ff tx
Explain PID, ON/OFF, Controls
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
How can you add value to this Industry if offered the job?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
what is stroke check for field instument transmetter's & AOV's