in ceiling fan and table fan what is the rotating part and
what is the stationary part?
Answer Posted / k.prakashchandra
In both, the squirrel cage armature is the rotor.In table
fan the rotor is inside the field and in case of the ceiling
,the rotor is outside the field.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Draw the DOL starter and star delta starter drawing?
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
How are load losses and no-load losses measured at site in a DG set?
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
in my industry we are using 3 step up transformers for induction heaters..i.e 415/580v and other are 11/440v.in power consumption does a step trnsformer makes any difference compared to step up?? plz explain
What is Bolted fault?
what is gridrotor resistance starter
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
what are the stresses in circuit breakers ?
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
Give some example of fault limiting devices?
can the measured percentage error during calibration of single phase energy meter be negative?
what are the main applications of transistor in non-linear region?