Interested to Buy Any Domain ? << Click Here >> for more details...
i have a roll dia aprox.43 inches and gear box ratio is
14.3.so my question is how was decide the kw rating of
motor.
- 1 Answers
- 3071 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
First you buy a torque wrench. Then with the wrench you
turn the gear box at the speed you want the roll to go.
Then go here
http://www.engineeringtoolbox.com/electrical-motors-torques-
d_651.html
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to meas-our losses for L.T & H.T
for opening electrical shop, tips needed.
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
What is the control action?
What is zero of the system?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What is the tube exial fan?
What is the cut-off rate?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
What are the basic elements used for modeling mechanical translational system?
Form S and "c" license application both are same? @ tneb portal
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
Can we Co-ordinate relay in Load Break switch?
