Interested to Buy Any Domain ? << Click Here >> for more details...
Q : How to calculate cooling water pumps head, do I need to
consider static head and frictional loss of the pipe with
high elevation? I mean to say is discharge pipe branches to
several elevations and joins to the cooling water return
line.
The highest elevation pipe goes to a heat exchanger at (xx)
psi inlet pressure. Should I consider only pump discharge
header and this piping for head calculations?
How about frictional losses in return pipe? Pressure
recovered in return piping is good enough to make it back
to the cooling tower?
- 1 Answers
- 10667 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Pump Discharge Pressure = Max. Discharge static head (pump
discharge nozzle to max. pipe elevation routed)+ max.
discharge pipe length friction loss (including supply &
return pipe line to/from heat exchanger to cooling
tower)+pressure losses in no of valves & fittings (isolation
valve, control valve, bends, expander, reducer, T joint )+
pressure losses in no of equipments like heat
exchanger(condenser)+ exist loss in cooling tower
Note: no need to consider all branches pipe line for total
friction losses. consider max. branch pipe length & do not
forget to cross check that calculated pump discharge
pressure is enough sufficient to meet pressure requirement
in remaining branch pipe lines.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What happen when too much cylinder oil is injected in the working cylinder?
For example, If raised PR (purchase request) of 1"inch ss pipe so what description in mention in purchase request?
How to stop a purifier?
Which heating value is indicated by a calorimeter and why ?
can u give me model question papers for exam preparation .
Can an airplane fly without a tail?
Who are the leaders among expansion valve manifacturers? what are the recent developements in the expansion valve industry, used in refrigeration abd air-conditioning?
HOW TO SELECT DG SETS AND DETAILED INFORMATION OF THE TERMS INVOLVED IN THE BROCHURES OF THE COMPANY?
Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison
Explain the difference between projectile motion and trajectory?
At 50 Centigrade (Fuel oil) what is its cast?
What is isotropic material ?
What will you do when scavenge fire happened?
What does a pump develop? Give reason to support your answer.
what is draft and draft loss?in a boiler,how is draft created?
