what is the difference b/w low voltage motors & medium
voltage motors
- 1 Answers
- 3700 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
Low voltage operates at 600 volts or less
Medium voltage is up to about 13 kv.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how to modify DOL control panel into Delta Y connection?
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
what is the difference between torque induced and torque load?compare them with respect to dc motor?
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
What is knee point voltage of transformer?
Transformer how to maintaince a check b check c check d check
what will happen if ac and dc supplies given
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
How does PLC work for sychronising of Two or more DG sets?
state the working of discharge lamp?
