Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / irfan
Self-Monitoring, Analysis, and Reporting Technology
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What is the cascade control
which type of signal used in instrument?
What is zener diode? What is voltage regulator?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
Explain working principle of lvdt?
steps for installing orifice plate?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
what is the calibration procedure for magnetic flow meter @ onsite
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
Why MUX JB's are using only Temperature Element in Fundation field bus?
What is the basic difference between Modbus and CAN Open Protocols
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How to calibrate Magnetic flow Transmitter in Field
What is the reason PT speed not incresed in gas turbine?
