Interested to Buy Any Domain ? << Click Here >> for more details...
which inert gas is most apt to be used in a fluorescent lamp??
why ??
- 1 Answers
- 3694 Views
- I also Faced
- E-Mail Answers
Answer Posted / sthita prajna nayak
Argon
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
draw singleline diagram of star to delta and dol starters
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
33kv Rated output avilable in market (any where in india)
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
Please define ohm’s law for a.c (alternating current)?
what is mean by D.O. in distribution line poles?
why servomotor motor? where i apply for best output?
What are m circles?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
how to get bearing & winding temperature of an induction motor?
