Interested to Buy Any Domain ? << Click Here >> for more details...
What is D check in a Diesel generator for 1000kva DG
- 9 Answers
- 39464 Views
- Escorts, I also Faced
- E-Mail Answers
Answer Posted / raj saini
A Check : Coolant check, battery volt, all connection ,
lube oil level, cleaning, air filter on daily.
B Check : A+ all filter except air filter (lube oil
filter , fuel filter , by pass filter, coolant filter) &
lube oil change after 300 Hrs or 6 month
C Check : A+B+Taped setting, Air filter change after 1500
Hrs or One Year.
D Check : All engine over holing after 2000 Hrs or Two Year
if we do not done the A+B+C check as per the above
mentioned time frame .If it has been done routinely then D
check don't required.
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
Write down the name of 2 lady Bir Pratin of Bangladesh
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
If a high resistance fault occurs,then what are the changes will happen in the system?
why using transformer and thyristor switch in 3 phase apfc panel
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
how to design the heater in temperature control unit to heat 50KL of water?
can you any one give exact mathematical relation between AC current and DC current?
we have a rewind motor of 2Hp,2800Rpm, 220Volt AC. how can we choose the running capacitor for this motor, any formula for that?
Difference between rating factor of cable and derating factor of cable?
Percentage losses in power generation?
why the voltage and current in a long transmission line are called travelling wave?
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
