The power showed in the name plate of the motor is input
power or output power??
The power showed in the name plate is 18.5kw
measured current is 34.5 amps. location is india.
can i calculate the efficiency of the motor using this
data??
Answer Posted / wareagle
The power showed in the name plate of the motor is input
power or output power?? Output
The power showed in the name plate is 18.5kw measured
current is 34.5 amps. location is india. can i calculate
the efficiency of the motor using this data?? Yes
Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
how point on wave controller works.
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
what is the carona effects meaning in HT line transmmission system
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
different aspects of voltage stability
Do you know what is dry-out test in x'mer
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
why high speed tripping relay will be used in tripping circuit why not normal relay
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
What are the conditions to be satisfied for parallel operation of dc generators?
At what speed 1 HP motor can run an electric car of weighing 400 kg?
What is the feedback in the control system?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value