Interested to Buy Any Domain ? << Click Here >> for more details...
In colomn reinforcement when dia of bar is going to change,
than what should be the lap length of bars weather it should
be of heigher dia bar lap length or it should the accordance
with new dia bar. the grade of concrete is same.
- 11 Answers
- 27850 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil kumar inabathini
5oD or 47D
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
What is made from large rocks, which protects the base of cliffs?
Design a cantilever slab to carry a live load of 2000 N/m2. The overhang of the slab is 1.20m. b) A slab over a room is 4.75m x 4.75m. The edges of the slab are simply supported and the corners are not held down. The live load an the slab is 300 Kg/m2. The slab has a bearing of 15cm. On the supporting walls. Design the slab as per Rankine - Grashoff theory. Assume weight of R.C.C. = 2400 Kg/m2.
what is the sequence of the activities in the typical under ground water tank including civil & MEP works.
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
what is thumb rule for calculating the size of ISMB required for a particular length of span
Formula of area of crane hook
What are your future hopes for this job?
how to estimate man power for estimating the time required for completion of a project in terms of carpenters,barbenders,masons for block work ,masons for plasteing ,unskilled labour, painters, tiles masons,plumbers and electricians for medium and high rise constructions and independent villa projects.
How to calculate the cement and fine aggregate requirement for solid block masonry works in terms of Sqm. 1. 400x200x200mm 2. 400x200x100mm 3. 600x200x100mm 4. 600x200x200mm I need the answer for 1 Sqm of solid block works.
How much cement will require for 1Rmt Skirting laying
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
What is the tensile strength of marble?
Why are separation membranes used between concrete pavement slab and sub-base?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
