Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pravin bhoi
The ac eqmnt wrkng based on principle of alterntg flux or curnt whch is nt psble with dc so..
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
what is arc flash and what are the hazards involved
what are the protecyion of transformer & generators
can u give me a brief idea about power line carrier communication ??
are there rmu for 3 transformer?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
Do u know any one? how to find out in motor rated amps? formula?
im electrical engineer, could any one help me for FEWA exam questions please ?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
How to calculate the Harmonics losses in terms of cost/unit.
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
What is knee point voltage of transformer?
Is RTCC panel needs any control supply.
