Answer Posted / dnyanadev
Trim means CUT.
| Is This Answer Correct ? | 0 Yes | 9 No |
Post New Answer View All Answers
What is motion balance principle?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
what are the selections available in configuring a burnout protection of a controller? thanks
How is flow measured in square root?
diff between neutral ,ground,phase , earthing and shielding?
what are procedure of sox-nox calibration
Explain working principle of lvdt?
how can use ram
If we increase only P what will be controller action ?